To install the EZABL Pro™ on the Zyltech Gear, you will follow our EZABL Installation Guide, found here: EZABL Pro Installation Guide
In section 3 of the installation guide, you will be required to install a Z endstop cable between the mainboard and the EZABL control box. Please see below for the proper wiring of this cable.
The Zyltech Gear requires the use of an additional Z endstop cable not provided with the machine. This cable is included as an accessory to the EZABL Pro™ kit for the Zyltech Gear or as a standalone item.
This cable connects the EZABL control box to the Z+ connector on the MKS Robin board. MKS uses colored JST connectors for these ports, the connector on our review unit’s board is green:
Connect the extended Z Endstop cable to the Z+ header on the Zyltech Gear’s Robin Nano board as seen here
The other end of the Z endstop cable goes into the EZABL control box as seen in our EZABL instructions.
