Installation Directions
- Connect the cable end with the label that says “THIS END GOES TO SENSOR” to the EZOut V3 Sensor
- Plug the other end into your control board
- Update your firmware on your board
- Add M75 to your starting Gcode at the very beginning
- Feed your filament through the sensor
- Slice and print!
Specifications
- Injection Molded PC-ABS (black)
- Curved Detection Switch to Avoid filament snags
- Tapered Inlet and Outlet
- Lightweight (1oz) For Inline Installation
- 1 Meter Filament Sensor Cable Included
- Sensor housing style may vary from what is pictured
- V2 and V3 sensors are the same sensor – The difference is the cable they come with
Pinout
- Red = VCC (3.3-5V DC)
- Black = Ground
- White = Signal
Sensor Logic Settings
- Marlin 1.1.X uses FIL_RUNOUT_INVERTING false
- Marlin 2.0.6+ uses FIL_RUNOUT_STATE LOW
WARNING: Do NOT use the V3 sensors with any previous EZOut V1 or V2 adapter boards. These are ONLY intended to be used on their own and directly connected to a control board with the supplied cable. Do NOT use other cables with our V3 sensors other than the cable it comes with.
